IICRC-certified crews for fire and water damage, 24/7 in San Diego County

Fire and Flood Restoration SOLANA BEACH CA Done Right the First Time

Fire and Flood Restoration SOLANA BEACH CA means one crew handles both the burn damage and the water left behind by firefighting. We extract standing water, dry the structure to ANSI/IICRC S500, remove soot and smoke residue, and rebuild what the fire took. When you search for fire and water damage restoration in SOLANA BEACH, you get a licensed, insured team that answers the phone at 2 a.m. and starts work the same day.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Fire Damage Restoration Solana Beach — Fire Damage Restoration you can rely on
Careful work. Honest options.
About this service

What Fire and Flood Restoration SOLANA BEACH CA Really Involves

Fire and Flood Restoration SOLANA BEACH CA is the combined cleanup and rebuild of a property hit by fire and then soaked by the water used to put it out. The two problems have to be handled together: charred framing and melted wiring come out, and the same visit starts extraction and structural drying before mold sets in. We test moisture with meters and thermal imaging cameras, map the wet zone, then run air movers and dehumidifiers until the readings match a dry standard. Only then does soot removal and reconstruction begin.

In Solana Beach, the call usually comes after a kitchen fire, an electrical fault in an older condo, or a garage fire that spread into the attic. Coastal humidity off the bluffs slows drying, so we run longer dry cycles than inland crews do. If you need fire and flood restoration near me in SOLANA BEACH CA, we handle the emergency fire and flood cleanup, the smoke odor, and the rebuild under one CSLB-licensed contractor, which keeps your insurance claim simple.

  • ✓ One Crew, One Claim
  • ✓ Dry Standards, Not Guesswork
  • ✓ Odor Gone, Not Covered Up
  • ✓ Local Response, Day or Night
What's included

What Fire and Flood Restoration Includes

The scope below covers the standard fire and flood job. Some items depend on how far the fire and water traveled, and we tell you which ones apply after the assessment, not after the invoice. Anything outside the scope gets quoted separately before we start.

✓

Emergency Board-Up and Tarp-Over

Broken windows, damaged doors, and roof fire damage get sealed the same visit. This prevents rain intrusion and theft while the claim is processed, and it is usually the first thing your adjuster asks about.

✓

Water Extraction and Structural Drying

Truck-mount extraction removes standing water, then air movers and dehumidifiers dry the structure to ANSI/IICRC S500. Daily moisture logs with meter and thermal imaging readings go into your claim file.

✓

Soot, Smoke, and Odor Removal

Soot sponges, dry ice blasting, and HEPA air scrubbers remove residue from surfaces and air. Thermal fogging and hydroxyl generators neutralize odor in framing and ductwork, not just in the room where the fire burned.

✓

Debris Removal and Contents Handling

Charred material and unsalvageable contents come out and get hauled away. Salvageable items are cleaned and stored. We photograph contents before removal so the insurance inventory is accurate.

✓

Structural Rebuild to Code

Framing, drywall, insulation, and roofing shingles go back under our CSLB license, with permits pulled through the city. Electrical and roofing trades are coordinated on the same schedule so the job does not stall.

✓

Final Moisture and Air Quality Verification

We re-check moisture readings and run an air quality pass before handover. You get the drying logs, photos, and final walkthrough in writing. If a reading is off, we return at no charge.

How it works

How Our Fire and Flood Restoration Process Works

01

Emergency Board-Up

We secure the property first: board-up on broken windows, tarp-over on roof fire damage, and shutoff of utilities that are unsafe. This usually happens within the first two hours. It stops rain, wind, and trespassers from adding to the loss while the claim is being filed.

02

Water Extraction and Drying

Firefighting water gets pulled with truck-mount extractors, then the structure goes on a drying system of air movers and dehumidifiers. We log moisture readings daily against a dry standard. A typical Solana Beach condo takes three to five days; a soaked crawlspace can run seven.

03

Soot and Smoke Removal

Soot sponges, dry ice blasting, and soda blasting lift residue from framing and masonry without gouging the surface. We seal charred framing with smoke sealant and replace insulation and drywall that cannot be cleaned. Ductwork gets cleaned or replaced, because that is where the smell hides.

04

Structural Repair and Rebuild

Charred lumber, cracked drywall, melted wiring, and damaged roofing shingles come out and go back to code. We pull permits through the city and coordinate licensed trades for electrical and roofing. Most rebuilds run two to six weeks depending on scope and material lead times.

05

Final Verification and Walkthrough

Before we hand back keys, we re-check moisture, run an air quality pass, and walk the property with you room by room. You get the drying logs, photos, and invoices your adjuster needs. If anything reads wrong, we come back at no charge.

Tools & methods

Tools and Methods We Use on Every Job

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Thermal Imaging Camera

Finds hidden moisture behind walls and ceilings without opening them. We use it to map the wet zone before extraction and to confirm the structure is dry before rebuild.

Moisture Meter

Reads moisture content in drywall, framing, and subfloor. Daily readings against a dry standard are what your adjuster uses to approve the drying phase.

HEPA Air Scrubber

Filters smoke particles and soot out of the air during cleanup. Essential when ductwork is being cleaned or when demolition kicks up residue.

Hydroxyl Generator

Neutralizes smoke odor in occupied spaces without the ozone concerns of older equipment. We run it in rooms where contents are still present.

Thermal Fogger

Pushes odor counteractant into framing cavities and ductwork where smoke residue hides. Used after surface cleaning, not instead of it.

Dry Ice Blaster

Lifts soot from masonry and framing without gouging the surface or adding water. Useful on brick and exposed beams where abrasive cleaning would do damage.

Dri-Eaz and Phoenix Dehumidifiers

Pull moisture out of the air so the structure can dry. We size the unit count to the cubic footage and the coastal humidity, not to a flat formula.

Real results

Before and after.

Kitchen Fire and Water Loss, Town Center

Before

A grease fire in a Town Center condo brought the fire department and about two inches of standing water across the living room floor. Soot covered the cabinets and ceiling, and the smoke had already reached the bedroom closet.

After

Water was extracted the same night and the unit dried in four days to ANSI/IICRC S500 standards. Cabinets were degreased, two fronts replaced, and the ceiling repainted. Final moisture readings matched the dry standard in every room.

Attic Fire and Ceiling Water Damage, Lomas Santa Fe

Before

An attic fire soaked the insulation and sent water down through two ceilings. Charred framing ran along one rafter bay, and the roofing shingles above it were damaged enough to leak.

After

Saturated insulation came out, framing was dried and sealed with smoke sealant, and damaged shingles were replaced. Moisture readings returned to dry standard in six days, and both ceilings were rebuilt and painted.

Garage Fire and Slab Water, Eden Gardens

Before

A garage fire melted wiring along one wall and left standing water across the slab. Smoke had traveled into the adjacent hallway, and the garage door opener was destroyed.

After

The garage was boarded up the same visit, water was extracted, and the slab dried in three days. A licensed electrician replaced the melted wiring, and the garage passed inspection on the first walkthrough.

Problems we solve

Problems We Solve for Solana Beach Property Owners

The damage you see after a fire is only part of the loss. The water, the smoke, and the mold that follows are what turn a two-week job into a two-month one. Here is what we run into most often on the coast.

Ask a pro →
01

Standing water from firefighting soaking floors and subfloor

We extract standing water the same visit and place drying equipment before the first night is out. Moisture meters and thermal imaging cameras confirm the subfloor is dry before any new flooring goes down.

↗
02

Smoke odor returning weeks after the fire

We clean or replace ductwork, use hydroxyl generators and thermal fogging with odor counteractant, and seal framing with smoke sealant. The smell is neutralized at the source, not covered.

↗
03

Mold growth after fire and water damage

We dry to ANSI/IICRC S500 standards and follow ANSI/IICRC S520 if mold is already present. Containment, HEPA air scrubbers, and removal are handled by the same crew that did the fire cleanup.

↗
04

Insurance claim stalling between mitigation and rebuild

We scope mitigation and rebuild under one license and one set of photos. Your adjuster gets a single consistent file, which shortens approval and gets you back in sooner.

↗
Proof you can check

Licensed, Certified, and Documented

✓
IICRC Certified FirmInstitute of Inspection, Cleaning and Restoration Certification
✓
IICRC WRT (Water Restoration Technician)Institute of Inspection, Cleaning and Restoration Certification
✓
IICRC FSRT (Fire and Smoke Restoration Technician)Institute of Inspection, Cleaning and Restoration Certification
✓
IICRC ASD (Applied Structural Drying)Institute of Inspection, Cleaning and Restoration Certification
✓
EPA Lead-Safe Certified FirmU.S. Environmental Protection Agency
✓
California Contractors State License Board (CSLB) LicenseCalifornia Contractors State License Board
Good questions

Frequently Asked Questions About Fire and Flood Restoration

(833) 929-6186 →

Most residential fire and flood restoration jobs in Solana Beach run $3,500 to $18,000 in 2026, with larger structural rebuilds going higher. Emergency water extraction and drying alone typically lands between $1,200 and $4,500 depending on square footage and how long the water sat. Smoke and soot removal adds $800 to $3,000. We quote the scope before work begins so you can compare it against your insurance estimate.

We do, and we are based in San Diego County, not dispatched from out of the area. Our crews handle both the fire damage and the water left by firefighting, which is the part most homeowners forget to plan for. Call (833) 929-6186 and we will confirm a dispatch window for your address in 92075 or 92014.

Yes, and it should be. Fire damage and the water used to extinguish it have to be scoped as one job, because drying decisions affect what gets rebuilt. If you dry first and rebuild later with a different contractor, moisture gets trapped behind new drywall and you end up with mold. We sequence extraction, drying, soot removal, and rebuild on one schedule under one license.

Standard homeowners and commercial property policies in California typically cover fire damage and the water damage caused by firefighting, since the water is a direct result of a covered peril. Flood from outside the building is a separate policy through the NFIP or a private carrier. We document the loss with photos and daily moisture logs so your adjuster can separate the two clearly.

Ready when you are

Call for Fire and Flood Restoration SOLANA BEACH CA Now

Water is still spreading under your floors while you read this. Our line is answered 24/7, and a licensed crew can be at your Solana Beach address within 60 to 90 minutes. One call covers extraction, drying, soot removal, and rebuild.

Get Emergency Help (833) 929-6186 →
Request an appointment

Call Our SOLANA BEACH Fire Damage Crew

Fire losses do not keep business hours, and neither does our phone line. Call (833) 929-6186 any time, day or night, and describe what happened. We will ask about the rooms involved and the state of the roof and utilities, then dispatch a crew with board-up materials and extraction gear. Most emergency calls in Solana Beach get a tech on site the same day.

Request received — our team will be in touch shortly.
Tap to call(833) 929-6186